Porter-cable 447k Manuel d'utilisateur télécharger pdf (Page 12)

INSTALLING AND CARE OF DUST BAG

A dust bag is available as an accessory. Install dust bag as follows:

1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

2. Swing open exhaust cover (A) Fig. 12, and clean out any sawdust that

may have accumulated.

3. Insert dust bag tube in exhaust opening and push in until seated.

4. To remove, grasp dust bag tube where it enters exhaust opening and

pull out.

5. Unzip bag and shake out sawdust. Occasionally turn bag inside out and

brush out thoroughly.

CAUTION: To avoid personal injury from flying sawdust, the

exhaust cover should be kept closed at all times the dust bag is not

assembled. NEVER insert foreign objects into exhaust opening.

VACUUM CLEANER ADAPTER

An accessory vacuum hose assembly is available for connecting the exhaust

nozzle directly to a shop type vacuum cleaner.

RIP GUIDE

A rip guide (A), Fig. 13, is available as an accessory. Install rip guide as

follows:

1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

2. Insert rip guide through

slot in right side of saw base.

Slide the guide in until it

extends through the slot in left

side of base.

3. Position the compression

spring to the thumb screw

(supplied with the rip guide),

and thread into the hole in the

saw base. DO NOT TIGHTEN.

4. Adjust the rip guide for the

desired width of cut and tighten

the thumb screw.

CAUTION: To avoid personal injury and damage to workpiece, the

rip guide must always extend through both slots in base.

OPERATION

HOW TO USE THE SAW

For maximum protection of the operator, effective control of this powerful

saw requires two-handed operation.

WARNING: It is important to support the work properly and to hold

the saw firmly to prevent loss of control which could cause personal

injury. Fig. 14 illustrates proper hand support of the saw.

Clamp work on a rigid support such as a bench or saw horses. See Fig. 14.

Mark the line of cut on the work. Be sure cut-off line is beyond end of support

to the right only enough to allow proper operation of the telescoping guard.

Place front edge of saw squarely on work before starting motor. Sight the

Fig. 13

900003 - 04-09-02.qxd 4/18/02 7:42 AM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Commentaires sur ces manuels

Pas de commentaire

Porter-cable 447k Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Porter-cable 447k