Part No. 900487 - 09-12-03Dovetail Fixture/JigInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these
101/2" AND 1/4" HALF-BLIND RABBETED DOVETAILSPREPARING ROUTERPrepare router the same as that for 1/2" or 1/4" half-blinddovetails
111/2" BOX JOINTSNOTE: Any material up to 13/16" thick can be joined together with box joints.PREPARING ROUTERPrepare router the same as for
12ROUTING BOX JOINTS1. Before turning on router, place it on templet and make sure bit will not hit Dovetail Fixture/Jig as it cuts into scrapmaterial
13MAINTENANCEACCESSORIESKEEP TOOL CLEANPeriodically blow out all air passages with dry compressed air. Clean all plastic parts with a soft damp cloth.
14PORTER-CABLE LIMITEDONE YEAR WARRANTYPorter-Cable warrants its Professional Power Tools for a period of one year from the date of original purchase.
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®, BAMMER®,B.O.S.S.®, Builder
21. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries.2. AVOID DANGEROUS ENVIRONMENT. Don’t expose power tools to rain. Don’t use powe
316. AVOID UNINTENTIONAL STARTING. Do not carry a plugged-in tool with finger on switch. Be sure switch is off when plugging in. Keep hands, body and
NOTE: Refer to Fig. 1 for the various parts of the Model 4112 Dovetail Fixture/Jig.1. Insert jam nuts, item 18, into each of the outside recessed are
5IDENTIFYING DRAWER PARTSIt is recommended that scrap lumber be used when making your first dovetail cut so all adjustments and fits can bechecked to
61/2" HALF-BLIND DOVETAILSPREPARING ROUTER1. DISCONNECT ROUTER FROM POWER SOURCE.2. Insert templet guide, (A) Fig. 4, in hole (B), in router sub-
72. Place drawer front “inside up” under top clamp bar and against side of drawer which is extending above surfaceof Dovetail Fixture/Jig.3. Place the
89. Fig. 11 shows both the left and right corner of a drawer fitted together after they were both routed from the leftend of the templet. Note the loc
1/4" HALF-BLIND DOVETAILSPREPARING ROUTERPrepare router the same as for 1/2" half-blind dovetails except install 42054 templet guide, 43639
Commentaires sur ces manuels