Porter-cable 447k Manuel d'utilisateur télécharger pdf (Page 14)

BEVEL CUTTING

Bevel cuts are made in the same manner as crosscuts and rip cuts. The only

difference is that the blade is set at an angle between 0° and 45°, as shown

in Fig. 16.

The bevel cut made at an angle to the edge of a board is called a compound

cut. There are certain compound cuts, on which it may be necessary to

manually retract the telescoping guard to allow the blade to enter into

and/or through the cut.

CAUTION: Use the lever (A) Fig. 14, provided on the telescoping

guard when you have to retract the telescoping guard manually.

POCKET CUTS (PLUNGE CUTTING)

A pocket cut is one which must be made inside the area of the material and

not starting from the edge. Mark the area clearly with lines on all sides. Start

near the corner of one side and place front edge of saw base firmly on the

work. Hold saw up so blade clears the material. Be sure you have adjusted

the blade properly for depth of cut. Push the telescoping guard lever all the

way back so the blade is exposed as shown in Fig. 17. Start the motor and

lower the blade into the work. After the blade has cut through, and the base

rests flat on the work, follow the line right up to the corner. Use a keyhole or

bayonet saw to cut the corners out clean.

Fig. 16

Fig. 15

900003 - 04-09-02.qxd 4/18/02 7:42 AM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17

Pas de commentaire

Porter-cable 447k Manuel d'utilisateur Page 14