Porter-Cable 3802 Manuel d'utilisateur

ESPAÑOL: PÁGINA 21FRANÇAISE : PAGE 4112" CompoundMiter SawInstructionManualPart No. 900988 - 11-30-00The Model and Serial No. plate is located on

1010To adjust the sliding fit between the movable table and the base,turn nut (A) Fig. 14, clockwise to increase the sliding fit(opposite to decrease

1111ATTACHING OPTIONAL WORK CLAMPThe work clamp is an important accessory. Afterpurchase, the work clamp can be attached to any oneof the four holes (

121. The cuttinghead of your compound miter saw can be tilted to cut any bevel angle from a 90 degree straightcut-off to a 45 degree left bevel angle

1313ADJUSTING 0 AND 45 DEGREE BEVELPOSITIVE STOPS1. DISCONNECT THE SAW FROM THE POWERSOURCE.2. Adjust saw so that both bevel and miter pointers areset

1414Correct adjustment provides for a good snug sliding fit between these two parts. This adjustment should not beso tight that it restricts the tilti

1515TYPICAL OPERATIONS AND HELPFUL HINTS1. Before cutting, make certain the cutting arm andtable area are at their correct settings and firmlylocked i

1616CUTTING BOWED MATERIAL1. When cutting flat pieces, first check to see if the material is bowed. If it is, make sure the material is positionedon t

1717CUTTING CROWN MOULDINGOne of the many features of the saw is the ease ofcutting crown moulding. The following is an example ofcutting both inside

1818MAINTENANCECHANGING THE BLADEWARNING: USE ONLY CROSS-CUTTING SAW BLADES. DO NOT USE BLADES WITH DEEP GULLETS ASTHEY CAN DEFLECT AND CONTACT GUARD1

1919BRUSH INSPECTION AND REPLACEMENTCAUTION: BEFORE INSPECTING BRUSHES, DISCONNECT THE MACHINE FROM THE POWER SOURCE.Brush life varies, depends on the

IMPORTANT SAFETY INSTRUCTIONSSAVE THESE INSTRUCTIONSREAD AND FOLLOW ALL INSTRUCTIONS.This tool was designed for certain applications.DO NOT modify or

2020NOTES

The following are trademarks of PORTER-CABLE Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.) (Les marques suivantes sont desm

325. WARNING: SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING, AND OTHERCONSTRUCTION ACTIVITIES contains chemicals known to cause canc

44REPLACEMENT PARTSWhen servicing, use only identical replacement parts.POLARIZED PLUGS: To reduce the risk of electric shock, this equipment has a po

UNPACKING1. Carefully remove the machine from the carton.Retain all packing materials until you have inspectedand satisfactorily operated the machine.

66MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION1. Rotate locking knob (A) Fig. 6, counter-clockwise as far as it will go to unlock. Depress lever (B)

773. Use a straight edge (C) Fig. 7C, to make the extension table (B) even with saw table (D), and tighten the twoscrews (A) Fig. 7B.4. Attach the fen

9. Position lock handle (M) Fig. 7J, on studand replace screw and spring (L) that wereremoved in STEP 7. NOTE: Lock handle (M) isspring-loaded and can

99DANGER: A TURNING SAW BLADE CAN BE DANGEROUS. AFTER COMPLETING CUT, RELEASE SWITCHTRIGGER (A) FIG. 12, TO ACTIVATE BLADE BRAKE. KEEP CUTTINGHEAD DOW